济南电动卷帘门安装维修卡住的处理方法

卷帘门在我们的生活中并不少见，现在，它们不仅用于工厂车库，也用于许多家庭。卷帘门是通过电机的转动带动传动轴转动，从而实现窗帘片的升降。当它上升时，帘片缠绕在卷轴上，当它下降时，帘片沿着导轨向下滑动。门帘的上升、停止和下降动作是通过遥控器的控制来实现的。还有一个停电手动释放系统，停电时可以通过手动摇杆提起卷帘门。

Rolling shutter doors are not uncommon in our daily lives. Nowadays, they are not only used in factory garages, but also in many households. The rolling shutter door drives the transmission shaft to rotate through the rotation of the motor, thereby achieving the lifting and lowering of the curtain panels. When it rises, the curtain wraps around the reel, and when it descends, the curtain slides down the guide rail. The lifting, stopping, and lowering actions of the door curtain are controlled by a remote control. There is also a power outage manual release system, which can lift the roller shutter door through a manual joystick during a power outage.

在中，的日常生活中，我们经常会遇到济南卷帘门不能放下或向上推的问题。造成这种情况的原因大多是两侧滑槽之间的长期摩擦，有些地方可能会损坏，所以拉不是很好。那么就有可能是卷帘门上的弹簧一侧断裂，导致方向错误和拉不好山东电动卷帘门是一种工业用门，控制系统是整套快开门的核心。如何确认卷帘门的性能是卷帘门控制系统的配置。因为卷帘门运行速度快，开关频繁，所以需要稳定的控制系统。没有好的控制系统，就没有好的快卷门。  如果出现上述情况，建议您首先检查两侧的滑槽，看看是否有损坏，然后拉打开门，看看门的方向是否偏离。如果滑槽或隐藏在滑槽中的门没有损坏，请润滑滑槽(因为润滑脂会持续更长时间)。如果还是不行，有可能是上面的弹簧坏了。

In our daily lives, we often encounter the problem of Jinan roller shutter doors not being able to be lowered or pushed up. The reason for this situation is mostly due to long-term friction between the sliding grooves on both sides, and some areas may be damaged, so the pulling is not very good. So it is possible that one side of the spring on the roller shutter door is broken, resulting in incorrect direction and poor pulling. Shandong electric roller shutter door is an industrial door, and the control system is the core of the entire set of quick opening doors. How to confirm the performance of the roller shutter door is the configuration of the roller shutter door control system. Due to the fast operation speed and frequent opening and closing of rolling shutter doors, a stable control system is required. Without a good control system, there is no good fast rolling door. If the above situation occurs, it is recommended that you first check the sliding grooves on both sides to see if there is any damage, and then pull open the door to see if the direction of the door deviates. If the chute or the door hidden in the chute is not damaged, lubricate the chute (as the grease will last longer). If it still doesn't work, it's possible that the spring on top is broken.

济南卷帘门的安装注意事项：

Installation precautions for Jinan rolling shutter doors:

1、检查洞口是否与产品尺寸一致，防火卷帘门洞口的尺寸，按3 m.

1. Check if the opening is consistent with the product size, and the size of the fireproof rolling shutter door opening should be 3 meters

2.确定安装的水平线和垂直线，按照设定的尺寸依次安装。槽口尺寸自上而下应准确一致。对应的槽口应在同一平面上，然后用连接件与孔中的预埋件焊接。

2. Determine the horizontal and vertical lines for installation, and install them in sequence according to the set dimensions. The groove size should be accurate and consistent from top to bottom. The corresponding groove should be on the same plane, and then welded with the connecting piece and the embedded part in the hole.

3.卷帘门应按照手册的要求安装。

3. The roller shutter door should be installed according to the requirements of the manual.

4、卷轴、框架板应牢固地安装在混凝土结构或预埋件上。

4. The scroll and frame plate should be firmly installed on the concrete structure or embedded parts.

5.宽门体需要在中，和滑道之间安装中柱。中柱的安装应与地面垂直且牢固，但应易于拆卸和组装。

5. The wide door body needs to be equipped with a center pillar between the center and the slide. The installation of the center pillar should be perpendicular to the ground and firm, but it should be easy to disassemble and assemble.