电动卷帘门维护的三个注意事项！

The electric rolling shutter door has good anti-theft function. At the same time, the electric rolling shutter door also saves us the trouble of manually opening and closing the rolling shutter door, so the electric rolling shutter door is widely used, so what are the three problems that need to be paid attention to in the maintenance of the electric rolling shutter door? Next, roll up the door for you to popularize it.

1、要保持轨道运行畅通，及时清理电动卷帘门的轨道，保持清洁，卷帘门电机和传动链条要经常加注润滑剂，检查控制箱内器件和开关控制盒，紧固接线端口，紧固螺丝等，清洁控制箱内、表面和按钮上的灰尘污物，按钮卡住而不能。

1. It is necessary to keep the track running smoothly, clean the track of the electric rolling shutter door in time, and keep it clean. The rolling shutter door motor and drive chain should be filled with lubricant frequently. Check the devices and switch control box in the control box, fasten the wiring port, fasten the screw, etc., and clean the dust and dirt in the control box, on the surface and on the button, so that the button is stuck and cannot be replaced.
                      

2、在电动卷帘门的使用过程中，要尽量保持控制器和电压的稳定，禁止安装在潮湿的环境，另外不要随意打开遥控器，如若发现门体上有电线缠绕、打结等应及时处理。注意通道的是否堵塞，阻碍门体下降，如若发生异响应停止电机运作。

2. In the process of using the electric rolling shutter door, it is necessary to keep the controller and voltage stable as far as possible. It is forbidden to install it in a humid environment. In addition, it is not allowed to open the remote control at will. If it is found that there are wires winding and knots on the door, it should be handled in time. Pay attention to whether the channel is blocked to prevent the door from falling. If abnormal response occurs, stop the motor operation.

3、要经常性的检查电动卷帘门上下行程的开关，对行程控制器加上润滑油，保持正常良好的运行，另外，操作人员手动控卷帘门，检查器运行情况，校对上下行程开关位置，使电动卷帘门开启或关闭时处于适当位置，且检查过程中严电动卷帘门冲顶或冲底或者反转，如若出现紧急情况应停止转动，切断电源。

3. In addition, the operator manually controls the roller shutter door, checks the operation of the device, and checks the position of the up and down travel switch, so that the electric roller shutter door is in a proper position when it is opened or closed, and the top or bottom or reverse of the electric roller shutter door is strictly controlled during the inspection, In case of emergency, stop turning and cut off the power supply.