电动卷帘门如何保养，四大措施供您参考

来源：http://www.jnyuqilin.com/  发布时间：2021-07-27 13:44:39

 电动卷帘门如何保养，四大措施供您参考：
How to maintain the electric rolling shutter door? Four measures are for your reference:
1、在电动卷帘门的使用过程中，要尽量保持控制装置和电压的稳定，禁止安装在非常潮湿的环境，另外不要随意打开遥控装置，如若发现门体上有电线缠绕、打结等应及时处理。注意通道的是否堵塞，阻碍门体下降，如若发生异响应立即停止电机运作。
1. During the use of the electric rolling shutter door, the stability of the control device and voltage shall be maintained as far as possible. It is forbidden to install it in a very humid environment. In addition, do not open the remote control device at will. If there are wires winding and knotting on the door body, it shall be handled in time. Pay attention to whether the channel is blocked to prevent the door body from falling. In case of abnormal response, stop the motor immediately.

2、要经常性的检查电动卷帘门上下行程的开关，对行程控制装置加上润滑油，保持正常良好的运行，另外，操作人员手动控卷帘门，检查器运行情况，校对上下行程开关位置，使电动卷帘门开启或关闭时处于适当位置，且检查过程中严防电动卷帘门冲顶或冲底或者反转，如若出现紧急情况应立即停止转动，切断电源。
2. Regularly check the up and down travel switch of the electric rolling shutter door, add lubricating oil to the travel control device to maintain normal and good operation. In addition, the operator manually controls the rolling shutter door, checks the operation of the device, and proofreads the up and down travel switch position to make the electric rolling shutter door in an appropriate position when it is opened or closed, In addition, during the inspection, the electric rolling shutter door shall be strictly prevented from punching the top or bottom or reversing. In case of emergency, the rotation shall be stopped immediately and the power supply shall be cut off.
3、操作员经常性的要检查好电动卷帘门的手动开关和手动升降装饰，以防止在紧急的情况下电动卷帘门会失灵，或者造成不必要的事故。
3. The operator shall regularly check the manual switch and manual lifting decoration of the electric rolling shutter door to prevent the electric rolling shutter door from failure or causing unnecessary accidents in an emergency.
4、要保持轨道运行通畅，及时清理电动卷帘门的轨道，保持内部清洁，卷帘门电机和传动链条要经常加注润滑剂，检查控制箱内器件和开关控制盒，紧固接线端口，紧固螺丝等，清洁控制箱内、表面和按钮上的灰尘污物，防止按钮卡住而不能弹回去。
4. Keep the track running smoothly, clean the track of the electric rolling shutter door in time and keep the interior clean. The motor and drive chain of the rolling shutter door shall be frequently filled with lubricant, check the components in the control box and the switch control box, fasten the wiring port, fasten the screws, etc., clean the dust and dirt in the control box, surface and button, and prevent the button from sticking and not bouncing back.