卷帘门怎样注重后期的保养?

来源：http://www.jnyuqilin.com/  发布时间：2024-04-09 15:27:58

选择一个好的卷帘门是非常重要的，同样重要的是在以后的使用中注意维护卷帘门。平时维护保养好卷帘门是非常重要的，以免因使用不当造成卷帘门损坏，直接影响产品的使用寿命。使用卷帘门时，我们可以注意以下事项：

Choosing a good roller shutter door is very important, and equally important is to pay attention to maintaining the roller shutter door in future use. It is very important to maintain the rolling shutter door well in daily life to avoid damage caused by improper use, which directly affects the service life of the product. When using roller shutter doors, we can pay attention to the following:

1.请勿用尖锐的硬物撞击门板，以免损坏门板，影响整体美观和使用寿命。

1. Do not use sharp hard objects to impact the door panel, as it may damage the overall appearance and service life.

2.请勿电机通电时检修和清洁，以免造成危险。

2. Do not inspect and clean the motor when it is powered on to avoid danger.

3.门体严禁接触酸碱溶液或腐蚀性气体，以免腐蚀门帘涂层。

3. The door body is strictly prohibited from coming into contact with acidic or alkaline solutions or corrosive gases to prevent corrosion of the door curtain coating.

4.使用卷帘门时，尽量保持控制器和电压稳定。严禁安装在非常潮湿的环境中，不要随意打开遥控器。如果发现电线缠绕在门上应该及时处理。注意通道是否堵塞，防止门下降，如有异常反应，立即停止电机运行。

4. When using roller shutter doors, try to keep the controller and voltage stable as much as possible. It is strictly prohibited to install in a very humid environment and do not open the remote control casually. If wires are found tangled around the door, they should be dealt with promptly. Pay attention to whether the channel is blocked to prevent the door from descending. If there is any abnormal reaction, stop the motor immediately.

5.定期检查电动卷门上下行程开关，给行程控制器添加润滑油，保持正常良好运行。此外，操作员手动控制卷帘门，检查检查运行状态，并检查上下行程开关的位置，以便电动卷帘门在打开或关闭时处于适当的位置。在检查过程中，应严格防止电动卷门碰顶、碰底或倒转。紧急情况下，应立即停止旋转并切断电源。

5. Regularly check the up and down travel switches of the electric rolling door, add lubricating oil to the travel controller, and maintain normal and good operation. In addition, the operator manually controls the roller shutter door to check its operation status and check the position of the up and down travel switches, so that the electric roller shutter door is in the appropriate position when opened or closed. During the inspection process, it is necessary to strictly prevent the electric rolling door from hitting the top, bottom, or reversing. In emergency situations, the rotation should be stopped immediately and the power should be cut off.