手动卷帘门安装步骤介绍

来源：http://www.jnyuqilin.com/  发布时间：2024-04-23 09:00:55

手动卷帘门安装介绍

Introduction to the installation of manual roller shutter doors

手动卷帘门构成：中柱、上罩、卷轴、卷帘门叶片、导轨。

Manual roller shutter door composition: center pillar, upper cover, scroll, roller shutter door blades, guide rail.

工具准备：老虎钳，冲击电钻、手手电钻、电焊机、切割机、螺丝刀、锤子、线坠、水平尺等。材料准备：中柱、上罩、卷轴、卷帘门叶片、导轨。

Tool preparation: pliers, impact drill, hand drill, welding machine, cutting machine, screwdriver, hammer, plumb bob, level, etc. Material preparation: center pillar, upper cover, scroll, roller shutter door blade, guide rail.

手动卷帘门安装步骤

Manual roller shutter door installation steps

1：根据测量出门框的大小以便确定卷帘门的大小，利用专业的切割工具切割出所需面积大小的卷帘门叶片。

1: Based on measuring the size of the door frame to determine the size of the rolling shutter door, use professional cutting tools to cut the required area of rolling shutter door blades.

2：根据门的宽度，切割好中柱，卷轴，以及导轨的宽度有，根据门的长度切割好门边框。

2: Cut the width of the center pillar, scroll, and guide rail according to the width of the door, and cut the door frame according to the length of the door.

3：确定好卷帘门的安装位置，并且利用线坠、水平尺等工具进行测量，，找准水平线和垂直线的位置，并且标注出来。

3: Determine the installation position of the roller shutter door, and use tools such as a plumb line and a level to measure, find the position of the horizontal and vertical lines, and mark them.

4：根据标注好的定位线的位置，开始安装卷帘门的边框。

4: According to the marked positioning line, start installing the frame of the roller shutter door.

5：根据卷门机的说明书所提示的方法步骤以及注意事项进行卷帘门机的安装。将组装好的卷帘门体固定好，然后将限位器找准位置装上，并试着运转。

5: Install the rolling shutter door machine according to the instructions and precautions provided in the manual. Fix the assembled roller shutter door body in place, then locate the limiter and install it, and try running it.

6：进行滑道、手动机构、包箱的安装。

6: Install the slide, manual mechanism, and packaging box.

7：对卷帘门进行调试，以确保后期的正常运行。

7: Debugging the rolling shutter door to ensure normal operation in the later stage.

通过以上的步骤，一扇经久耐用的手动卷帘门就安装好啦，其实他的安装方法也不是那么的困难，掌握了就很简单。

Through the above steps, a durable manual roller shutter door can be installed. In fact, its installation method is not that difficult, and mastering it is very simple.

手动卷帘门的维修方法

Maintenance methods for manual rolling shutter doors

故障1：卷帘门不能很好地卷成，圆柱装

Fault 1: The roller shutter door cannot be rolled up well and is installed in a cylindrical shape

维修方法：这种情况可能是弹簧折断或是弹簧连接带断裂行，在维修时只需要更换弹簧吊带即可。

Repair method: This situation may be caused by a broken spring or a broken spring connection strap. During maintenance, simply replace the spring strap.

故障2：卷帘门门锁打不开或是钥匙插不进去

Fault 2: The rolling shutter door lock cannot be opened or the key cannot be inserted

维修方法：这种情况有两种可能一是门锁损坏，而是钥匙孔有污垢导致的堵塞，前一种情况，进行门锁更换，就一种针对钥匙空洞进行去污清洁处理即可

Repair method: There are two possible scenarios in this situation: one is that the door lock is damaged, and the other is that the keyhole is blocked due to dirt. In the former case, the door lock should be replaced, while in the other case, the keyhole should be cleaned and cleaned to remove dirt

故障3：卷帘门在开启的过程中困难，不顺畅，发出刺耳的声音

Fault 3: The rolling shutter door is difficult to open, not smooth, and makes a harsh sound

维修方法：如果卷帘门是可以正常卷上去的，那么在卷帘门维修时就不用考虑卷帘门的弹簧损坏与否，这种情况一般都是卷帘门上的帘片卡子卡住导槽或是帘片变形所致，只要对卷帘门入导槽的槽口处进行维修。以及对卷帘门叶片进行平整级就可以啦。

Repair method: If the rolling shutter door can be rolled up normally, there is no need to consider whether the spring of the rolling shutter door is damaged during maintenance. This situation is generally caused by the clip of the curtain on the rolling shutter door getting stuck in the guide groove or the deformation of the curtain. As long as the groove where the rolling shutter door enters the guide groove is repaired. And just level the blades of the rolling shutter door.

故障4：卷轴运转困难，开启过程有反相的阻力

Fault 4: The scroll is difficult to operate and there is resistance in the opposite phase during the opening process

维修方法：这种情况，很可能是卷轴两端口的润滑度不够，与卷帘门叶片产生摩擦导致阻力生成，只需要在卷轴的两端均匀的涂抹上适量的润滑有即可。。

Repair method: In this situation, it is likely that the lubrication of the two ends of the scroll is insufficient, causing friction with the rolling shutter door blades and generating resistance. Simply apply an appropriate amount of lubrication evenly on both ends of the scroll..

本文由济南卷帘门友情奉献.更多有关的知识请点击:http://www.jnyuqilin.com真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

This article is dedicated by Jinan Roller Shutter Door. For more information, please click: http://www.jnyuqilin.com Sincere attitude. We will provide you with comprehensive service. We will gradually contribute more relevant knowledge to everyone. Stay tuned