卷帘门坏了如何修理，济南卷帘门维修公司告诉你

电动卷帘门坏了如何修理，济南卷帘门维修公司告诉你

How to repair the broken electric rolling shutter door? Jinan rolling shutter door maintenance company will tell you

一、在电动卷帘门的使用过程中，要尽量保持控制器和电压的稳定，禁止安装在非常潮湿的环境，另外不要随意打开遥控器，如若发现门体上有电线缠绕、打结等应及时处理。注意通道的是否堵塞，阻碍门体下降，如若发生异响应立即停止电机运作。

1、 During the use of the electric rolling shutter door, the stability of the controller and voltage shall be maintained as much as possible. It is forbidden to install it in a very humid environment. In addition, do not open the remote controller at will. If there are wires winding and knotting on the door body, it shall be handled in time. Pay attention to whether the channel is blocked to prevent the door body from falling. In case of abnormal response, stop the motor immediately.

二、要经常性的检查电动卷帘门上下行程的开关，对行程控制器加上润滑油，保持正常良好的运行，另外，操作人员手动控卷帘门，检查器运行情况，校对上下行程开关位置，使电动卷帘门开启或关闭时处于适当位置，且检查过程中严防电动卷帘门冲顶或冲底或者反转，如若出现紧急情况应立即停止转动，切断电源。

2、 Regularly check the up and down travel switch of the electric rolling shutter door, add lubricating oil to the travel controller to maintain normal and good operation. In addition, the operator manually controls the rolling shutter door, checks the operation of the device, and proofreads the up and down travel switch position to make the electric rolling shutter door in an appropriate position when opening or closing, In addition, during the inspection, the electric rolling shutter door shall be strictly prevented from punching the top or bottom or reversing. In case of emergency, the rotation shall be stopped immediately and the power supply shall be cut off.

三、操作员最好是经常性的要检查好电动卷帘门的手动开关和手动升降装饰，以防止在紧急的情况下电动卷帘门会失灵，或者造成不必要的安全事故。

3、 The operator should check the manual switch and manual lifting decoration of the electric rolling shutter door regularly to prevent the electric rolling shutter door from failure or unnecessary safety accidents in case of emergency.

四、要保持轨道运行畅通，及时清理电动卷帘门的轨道，保持内部清洁，卷帘门电机和传动链条要经常加注润滑剂，检查控制箱内器件和开关控制盒，紧固接线端口，紧固螺丝等，清洁控制箱内、表面和按钮上的灰尘污物，防止按钮卡住而不能反弹。

4、 Keep the track running smoothly, clean the track of the electric rolling shutter door in time and keep the interior clean. The motor and drive chain of the rolling shutter door shall be frequently filled with lubricant, check the components and switch control box in the control box, fasten the wiring port, fasten the screws, etc., and clean the dust and dirt in the control box, surface and button to prevent the button from being stuck and not rebounding.

以上就是电动卷帘门坏了修理的具体办法，你学会了吗？其他有关电动卷帘门的分享欢迎访问济南电动卷帘门安装维修：http://www.jnyuqilin.com/

The above is the specific method to repair the broken electric rolling shutter door. Have you learned it? Welcome to Jinan electric rolling shutter door installation and maintenance: http://www.jnyuqilin.com/